hobbyturnedobsession wrote:Yes sir! I'm also going through the hack job of the po, on top of my quick fix its. Its a mess but its getting better. She and I am definately going next time, and I will be better prepared. I destroyed my tool box on the last trip.
Pics of the cutout Randy!! You know I am going to call you to help me do mine... hahah
So far we've got Rick, Randy & Nick with scrap from me to do this. Who will be the 1st to post pics? Looks like Randy is the only one who has started so far.
ChaseTruck754 wrote:So far we've got Rick, Randy & Nick with scrap from me to do this. Who will be the 1st to post pics? Looks like Randy is the only one who has started so far.
Looks like I maybe going towards a 45 gallon tank on my silver Bronco Steve. Let me know if you run into any more Bronco rear cargo floor sections.
Next one I get would be for converting the back of the supercab if I do it - so I will be keeping it. Unless that is I find a 80+ bronco for diiiiiiirt cheap and you buy it for me in trade for cutting the rear floor out
SteveG wrote:One of you guys building access panels needs to take lots of photos and post them in the Tech section.
Ok, so I didn't take a lot of pictures, but I did take a couple (took them while I was building the bed). I posted in tech in the general section... fuel access panel... Let's see how everyone else is doing it!
So its not complete but is definately workable and I love having them on the column rather than spread across the dash. I ran a switch for the lights and a now separate switch for the trans fan. Also, I don't have matching gauges yet but they all do work.
Attachments
gauge pillar.jpg (48.45 KiB) Viewed 1036 times
gauge pillar 2.jpg (49.79 KiB) Viewed 1036 times
I'm just here for the views. It helps me feel wanted.
So an update. I finished mounting both seats and harnesses. Now I'm working on the rear bench seat mount. My attempt will be to make a seat mount where I can unbolt the seat and there is a mount there ready for my supplies to be sinched down. Not the easiest but I thought it would work good.
Attachments
rear seat mount.jpg (31.76 KiB) Viewed 937 times
Getting better at welding.
weld close up.jpg (96.25 KiB) Viewed 937 times
seats.jpg (74.73 KiB) Viewed 937 times
I'm just here for the views. It helps me feel wanted.
Well heres a few more pics of the rear seat mount / crap holder. There will be a bar between the two ammo cans, I need to make one last cut on the bottom portion of the leg mount. The way I see it, it should mount to the two existing bolt holes up front and the two in the center in the rear. The seat will unbolt and I can carry all my stuff without stuff flying everywhere.
Attachments
bottom view seat mount.jpg (67.52 KiB) Viewed 916 times
rear seat mount.jpg (26.02 KiB) Viewed 916 times
half packed.jpg (45.94 KiB) Viewed 916 times
I'm just here for the views. It helps me feel wanted.
Nice - you have any strap mounts on the thing you so can strap the stuff down and keep it from flying around while the truck bounces all over the place?
