Kel Fab Creations Bronco Build

[hobbyturnedobsession]

Looks good!

[Kel Fab Creations]

Ran out of bolts while installing the steering last night. Pretty much buttoned up though.

[Rmc]

Looks really good bro.

[tcm glx]

Damn that looks way good man!!

[Kel Fab Creations]

Thanks for the compliments guys!

I bought some used carpet the other day and got around to cleaning it today. Spent a couple hours pressure washing these pieces and the transformation is pretty amazing. Still needa do the front piece. No soap of any kind was used. The color has kind of faded to grey over the years but this will be WAY nicer than no carpet.

[ChaseTruck754]

Looks much better!

Did you pull your carpet yet? Any chance to look & see if they are the same or slightly different?

[Kel Fab Creations]

No, haven't pulled mine yet. I only have vinyl in the front. Nothing in the back. I did see that LMC doesn't sell a different part # for the different years though. We'll see. I'll be sure to update how it fits.

[crisis88]

Carpet looks good Kel. I'm going to start pulling mine out this week. Thanks for the moto.

[Jbfab]

So now that you have the swinger worked out will it be available on your site? Looks good but have to ask this, is your drivers side rotor solid? It might just be the angle and flash of the photo.

[Kel Fab Creations]

Ya, the steering parts will be available soon.

I like to run a solid driver side rotor because it gives you a better braking feel and the greater mass makes the vehicle roll better. It's not needed on the pass. side due to weight distribution when running the spare tire in the factory location.






























And if you buy that I'll throw the muffler bearings in free. Tricky camera flash I guess.

[Rmc]

http://kalecoauto.com/index.php?main_pa ... ucts_id=48

[Rmc]

I especially like the custom lowering kit that site offers.

[crisis88]

That has to be one of the best web sites I've ever seen!! I'm ordering the adjustable power band right now. Haha

[Kel Fab Creations]

Ya, that site is pretty funny. They have some new stuff from the last time I was there.

[yikes]

Work looks fantastic Kelly. Can't wait to finally see this in action.

[Rmc]

Btw kel I finally checked out your website cool products bro.

[Kel Fab Creations]

Thanks guys. It will be drivable tonight. We'll, tomorrow early morning. I'll be working on it till 3 or 4am. Then I'll just have to align it. Unless I run into a major show stopper I'll be driving it to work Thursday.

[bajascott]

Looks good man,it is turning out very nice,I wish I had the time to spend making stuff for.my bronco.but all my bronco time gets rushed! Haha

[Kel Fab Creations]

Looks good man,it is turning out very nice,I wish I had the time to spend making stuff for.my bronco.but all my bronco time gets rushed! Haha

I have sacrificed MAJOR sleep the last few weeks to get this thing drivable. Working on it while the family is sleeping has gave me another 3-4 hours a day.

[Kel Fab Creations]

I'm so pumped right now! Worked on the alignment this morning so I could drive it into work. Now I'm at work and all I wanna do is drive it. Can't wait for the drive home so I can do a little midnight Gilman Springs run.

I put the trimmed fender wells back in. I'll eventually probably make some nice aluminum ones.