Body mounts.

[kahuna bill]

i'm a bit late since you got ur mouts i went and got a 3" exhust, cut it lengthwise so that i could open it and used three 1/4"x1" flat stock with a hole drilled in the center to accept the body bolts. I than used them to pull the lower body mounts down. Used my impact and PB blaster.

IMG_20110323_171624.jpg (145.61 KiB) Viewed 699 times

IMG_20110323_170144.jpg (91.26 KiB) Viewed 699 times

[ChaseTruck754]

Looks like good setup. After I showed my buddy pics of the stuck drift in my earlier post he showed me a setup he had that is much like yours above. He used a big socket instead of the exhaust tubing though. It works well.

[kahuna bill]

i wish i had a socket that big... i started out with the 1/4" flat stock but bent the crap outta that, than moved up to two and again i bent those. finally after 3 1/4" stacks of flat stock they stopped bending enough for me to pull the mounts. they're frustrating little bastards.

[dtbback]

Energy Suspension Poly Body Mounts

2017-03-08 05.29.12.png (557.66 KiB) Viewed 464 times

For those who have replaced the factory mounts with poly mounts, can you tell me location of the mounts circled? They have a larger register diameter and I have no idea as to which position they belong. Thanks in advance.

[ChaseTruck754]

Been a loooong time since I have done these Will, but aren't those the rearmost ones? I seen to remember something having a hex shaped register, but I'm thinking that was the core support ones.

[RyanDS650X]

X2 on core support. Core support bushings dont have 2 pieces to them like the other body mounts do.

[dtbback]

Thanks guys!