C4 parts

Dezurfer · Post by **Dezurfer** » Sun Jun 15, 2014 8:39 am

looking for a C4 output shaft & a SBF bellhousing

Rmc · Post by **Rmc** » Fri Jun 20, 2014 4:04 pm

I have a small block c6 if you want stronger.

Dezurfer · Post by **Dezurfer** » Sun Jun 22, 2014 6:20 am

Want to stick with the length of the C4 & dont need more than 3 speed for my style of racing

hobbyturnedobsession · Sun Jun 22, 2014 12:40 pm

C6 is a 3 speed....

Rmc · Post by **Rmc** » Mon Jun 23, 2014 9:04 pm

I was going to tell him that too but figured what's the point.

cs_drums · Post by **cs_drums** » Tue Jun 24, 2014 12:35 pm

Youd be silly not to run the C6 over the C4. The differnec in length is only 3-4" if I remember correctly.

Dezurfer · Post by **Dezurfer** » Sun Jul 20, 2014 8:40 am

3"-4" in a Jeep driveshaft is a lot.

Plus, already had the built 2wd C4 in my hands.