WTB/WTT, Headers, Computer, Distributer, Axle

[big-d]

I am trying to get my project running. I am moving at the end of May and would like to be able to drive it onto the trailer for the move.

I am looking for headers (long tube or shorties) with 1 5/8" primaries for a 351w. Preferably with the EGR fitting, but not a deal breaker.

I need a WAY1, VEX1 or similar computer for my mass air conversion. Truck has E4OD trans.

A distributer with a remote mount TFI for a 351w.

A sterling 10.25 from a 92-96 dually pickup with 4.10 gears. ( not the cab & chassis model )

I am also looking for a battery, battery cables, coil overs, exhaust (cat and muffler, preferrably the largest magnaflow with 3" in/out)

I have a bunch of parts I can trade, or I can buy with cash.

I have a pair of never used Radflo bumps with a 4" stroke. Many ttb parts, forged 2wd beams, cast 2wd beams, D44 and D50 beam ends with knuckles, spindles and hubs. Stock trans cross members. Black steel wheels 15x8. Dick cepek DC1's 15x10 ( good width for small glass fenders). 8.8 axle housing, 2 D44 third members, both rebuilt (unknown mileage) 3.05 and 3.50 gears 2 sets of D44 TTB axles. EFI straight six intake manifold with throttle body. 4x4 C6 in unknown condition. NP 205 transfer case and many other brackets and random parts too. Just ask if you need something as I have to get rid of all of it before the move!

I am located in north phoenix.
Thanks,
Dustin

[SteveG]

I might have a distributor. I'll try to remember to look tomorrow.

[BIGRED351]

I have an MSD billet distributor, that I would trade for d44 spindles and hubs.

[BIGRED351]

I might be in Blythe April 18th. Could meet you in quartzite

[GoFastBro]

I have brand new flowtech shorty smog headers if youre still looking