Oregon Bumper Hieght Law

User avatar
Phoenix0783
Posts: 658
Joined: Thu Dec 10, 2009 12:50 pm
Bronco Info: No more Bronco :(
Location: Bend, OR
Contact:

Oregon Bumper Hieght Law

Post by Phoenix0783 »

I know there's a few people on here from Oregon so I though I'd post this up. You'd think that Oregon would have better things to do with unemployment above 10%... :roll:
Sema Action Network wrote: Oregon Reintroduces Bill to Limit Suspension/Tire Alterations

A bill (H.B. 3147) has been introduced in the Oregon legislature that would severely limit vehicle suspension, body lift and wheel/tire alterations. Specifically, H.B. 3147 would ban vehicles whose bumpers are elevated more than 3 inches over the original manufactured bumper clearance. Identical legislation was last introduced in Oregon in 2001.

We Urge You to Contact Members of the Oregon House Committee on Transportation and Economic Development (List Attached Below) Immediately to Request Their Opposition to H.B. 3147

· H.B. 3147 would ban reasonably altered vehicles due to overstated concerns with bumper mismatch.
· H.B. 3147 discriminates against hobbyists and aftermarket parts makers by leaving it solely to the vehicle manufacturers to choose bumper heights.
· H.B. 3147 would force owners of modified vehicles to spend large sums of money to reinstall original components.
· H.B. 3147 would ban useful alterations that provide adequate clearance for on/off road capability and accommodate heavy loads, larger tires, improved suspension and water-fording capability.
· H.B. 3147 would impose a fine of up to $360 per offense for vehicles that exceed the 3 inch clearance requirement.


DON’T DELAY! This bill tramples on the rights of 4x4 vehicle enthusiasts in Oregon. Please contact members of the House Committee on Transportation and Economic Development immediately by phone or e-mail to request their opposition to H.B. 3417.

Please e-mail a copy of your letter to Steve McDonald at stevem@sema.org. Also, please forward this Alert to your fellow car enthusiasts. Urge them to join the SAN and help defend the hobby! Thank you for your assistance.

Oregon House Committee on Transportation and Economic Development

Representative Cliff Bentz - Co-Chair
Phone: 503/986-1460
Email: rep.cliffbentz@state.or.us

Representative Tobias Read - Co-Chair
Phone: 503/986-1427
Email: rep.tobiasread@state.or.us

Representative E. Terry Beyer - Co-Vice Chair
Phone: 503/986-1412
Email: rep.terrybeyer@state.or.us

Representative Patrick Sheehan - Co-Vice Chair
Phone: 503/986-1451
Email: rep.patricksheehan@state.or.us

Representative Shawn Lindsay
Phone: 503/986-1430
Email: rep.shawnlindsay@state.or.us

Representative Nancy Nathanson
Phone: 503/986-1413
Email: rep.nancynathanson@state.or.us

Representative Jefferson Smith
Phone: 503/986-1447
Email: rep.jeffersonsmith@state.or.us

Representative Jim Weidner
Phone: 503/986-1424
Email: rep.jimweidner@state.or.us
My car is a hybrid; it burns gas and rubber.
User avatar
philofab
Basura Blanca
Posts: 5643
Joined: Tue Dec 08, 2009 9:37 am
Bronco Info: A pile of crap.
Location: Bullhead, AZ
Contact:

Re: Oregon Bumper Hieght Law

Post by philofab »

If you remove the bumpers how are they measured?
Follow me on Instagram. @philofab1 or Youtube https://www.youtube.com/philofab/
CBDuner
Posts: 148
Joined: Sun Oct 24, 2010 8:45 pm
Bronco Info: Wishing I had one!
Location: Coos Bay, OR
Contact:

Re: Oregon Bumper Hieght Law

Post by CBDuner »

Thanks for the post. Reposted it on the rest of the Oregon forums I'm on.
User avatar
Phoenix0783
Posts: 658
Joined: Thu Dec 10, 2009 12:50 pm
Bronco Info: No more Bronco :(
Location: Bend, OR
Contact:

Re: Oregon Bumper Hieght Law

Post by Phoenix0783 »

philofab wrote:If you remove the bumpers how are they measured?
Well, there is no bumper requirement in Oregon...
My car is a hybrid; it burns gas and rubber.
User avatar
Squarehead
Posts: 141
Joined: Fri Dec 11, 2009 5:41 pm

Re: Oregon Bumper Hieght Law

Post by Squarehead »

Pretty lame, hope you guys are able to successfully fight that bill.
Post Reply