Bronco suspension
Posted: Tue Aug 20, 2019 8:17 am
Hello everyone I know I haven't posted on here much, or at all besides my introduction, but some stuff has happened and I have had to sell off my project. I am trying to find my parts a good home and would like to sell everything as a whole if possible. Please contact my with any questions, thank you.
Parts list:
Bronco stock width C&T, plated, trussed & uniball pivots
Boxed radius arms w/brackets
Crossover steering swingers w/mounts
Tie-rods & modified pitman arm
Deaver Q-80 leafs w/rear shock mount & shackles
Bushing kits
2 - 1" uniballs
8 - 7/8"
2 - 1 1/4" hiems & hardware
Ford 9in axle truss Ruffstuff
Ruffstuff leaf spring perch U-bolt eliminator
Battery mount
New polyurethane body bushings
Ruffstuff pinion guard
Tail light bar with led lights (2 amber, 1 red)
ArtCarr gate shifter
2 - FOA 2.5in remote-resi coilovers (14in travel)
PAC racing coil springs
4 - FOA 2.5in triple bypass shocks (2 - 14in travel, 2 - 12in travel)
4 - Foa 2in bump stops with can mounts
2 - spare FOA resivor caps with hoses
FOA coil-over wrench
I am going to try to post pictures if I can figure it out.
Thank You Again
Mike
4085904102
Parts list:
Bronco stock width C&T, plated, trussed & uniball pivots
Boxed radius arms w/brackets
Crossover steering swingers w/mounts
Tie-rods & modified pitman arm
Deaver Q-80 leafs w/rear shock mount & shackles
Bushing kits
2 - 1" uniballs
8 - 7/8"
2 - 1 1/4" hiems & hardware
Ford 9in axle truss Ruffstuff
Ruffstuff leaf spring perch U-bolt eliminator
Battery mount
New polyurethane body bushings
Ruffstuff pinion guard
Tail light bar with led lights (2 amber, 1 red)
ArtCarr gate shifter
2 - FOA 2.5in remote-resi coilovers (14in travel)
PAC racing coil springs
4 - FOA 2.5in triple bypass shocks (2 - 14in travel, 2 - 12in travel)
4 - Foa 2in bump stops with can mounts
2 - spare FOA resivor caps with hoses
FOA coil-over wrench
I am going to try to post pictures if I can figure it out.
Thank You Again
Mike
4085904102