GoFastBroncos.com

I purchased this pack used and stripped it down to wire brush and paint all the leafs. The packs were re-assembled with new center pins and grade 8 hardware. They provide 3 inches of lift, and about 16-17" of wheel travel with the stock drive shaft and aftermarket shackle. They are 3" wide, bolt in, and could utilize the stock shackles. I will throw in the U Bolts as well.

$450
I am in San Diego

These are awesome leafs! Glws.

travis-- I can't swing the springs at this point but I need your help with something-- any chance at full droop like in the picture what the measurement is from the top of the housing to the bottom of the frame is?? Thx!

Pm sent.

VintageIronFab wrote:travis-- I can't swing the springs at this point but I need your help with something-- any chance at full droop like in the picture what the measurement is from the top of the housing to the bottom of the frame is?? Thx!

Is there no thread sacred? Dude, you're gonna owe everyone on this site a beer!

VintageIronFab wrote:travis-- I can't swing the springs at this point but I need your help with something-- any chance at full droop like in the picture what the measurement is from the top of the housing to the bottom of the frame is?? Thx!

I think my truck will hit the roof of my garage before it comes off the ground!

Nick wrote:

VintageIronFab wrote:travis-- I can't swing the springs at this point but I need your help with something-- any chance at full droop like in the picture what the measurement is from the top of the housing to the bottom of the frame is?? Thx!

Is there no thread sacred? Dude, you're gonna owe everyone on this site a beer!

( nick)
Glws Travis

Damn I want to ride in that truck so badly

Tchajagos wrote:Damn I want to ride in that truck so badly

Wait until it has links!


Sold by the way