Deaver F64 Leaf Pack

[Travisfab]

I purchased this pack used and stripped it down to wire brush and paint all the leafs. The packs were re-assembled with new center pins and grade 8 hardware. They provide 3 inches of lift, and about 16-17" of wheel travel with the stock drive shaft and aftermarket shackle. They are 3" wide, bolt in, and could utilize the stock shackles. I will throw in the U Bolts as well.

$450
I am in San Diego

[Nick]

These are awesome leafs! Glws.

[VintageIronFab]

travis-- I can't swing the springs at this point but I need your help with something-- any chance at full droop like in the picture what the measurement is from the top of the housing to the bottom of the frame is?? Thx!

[GETSOMEphoto]

Pm sent.

[Nick]

travis-- I can't swing the springs at this point but I need your help with something-- any chance at full droop like in the picture what the measurement is from the top of the housing to the bottom of the frame is?? Thx!

Is there no thread sacred? Dude, you're gonna owe everyone on this site a beer!

[Travisfab]

travis-- I can't swing the springs at this point but I need your help with something-- any chance at full droop like in the picture what the measurement is from the top of the housing to the bottom of the frame is?? Thx!

I think my truck will hit the roof of my garage before it comes off the ground!

[Rmc]

travis-- I can't swing the springs at this point but I need your help with something-- any chance at full droop like in the picture what the measurement is from the top of the housing to the bottom of the frame is?? Thx!

Is there no thread sacred? Dude, you're gonna owe everyone on this site a beer!

( nick)
Glws Travis

[Tchajagos]

Damn I want to ride in that truck so badly

[Travisfab]

Damn I want to ride in that truck so badly

Wait until it has links!


Sold by the way