GoFastBroncos.com

Looks great! Is that a drop center hood? Or just the light?

I thought the same thing, but I think it is the light

I still want a drop center hood, they make the front flares look trophy truck/rc car-ish, it just gives it the look of the tires having a place to go at full tuck. Amazing what a little paint can do huh? Slick truck for sure.

Yea its a factory hood, going to do fiberglass later on, trying to keep down time to a minimum, no fun just building and not using

Damn.,... That thing looks GOOD!!

Love the color!

I don't know, I kinda liked the red white and blue. It was very patriotic........

Thanks for the compliments, amp is installed, got some tunes again and started on front bumper , be ridin soon

Color is electric red, the original color of the truck

Got the 1st stage of the front bumper finished,time to drive it and see the bugs that creep out.....

Color looks nice!

Thanks......problem number one, some how front tank has a pinhole some where, new tank or fuel cell? Next issue gear oil is pouring out of ds axle seal, did feel alittle stiff going in though.

Parts geek.com has the seals.

The rust hole is probably on top next to the strap. My F250 has one there. I just don't fill the front tank all the way................

Yea the leak was right on the front strap but on the lower side, just got a replacement tank for now fuel cell would be to much of a pain right now

Oh I thought u ment the front axel seals were leaking, my bad.

,No one of those are leaking too, the only seals i didnt replace....drove around today, nice to ge back in my truck again ......i can see the potential for trouble on this build!

Been driving the truck for a few days, truck seems to wander just a bit, going to tighten up the box a little and see if that helps, have a little play in the box and maybe adjust the camber a little more.....

Check the tow in also.

,Yea i put it on the machine and adjusted the cams but should of probably went a little futher with the camber, i think its more on the postive side should of put it at zero to start with, but toe was adjusted after the camber was.....