2004 FORD Sport Trac

[AiiRaciing]

I was asked to post these over here for everyone to see. My girl is due with our 1st kid so Im hoping to have the truck done by then, 8/24/11



Camburg Front end:







Fox 3.0x18 3 Tube Bi-pass's

Fox 3.0x18 3 Tube Bi-pass's with Fox 2.0 4" stroke bumps

Sparco wheel and pedals:

Bump stop cans:

Fox bumps:

Coil Overs:

Limiting strap clevis:

Tube Clamps:

Lights for behind the grill:

Its time:


Now thats tight:










Beard RX-T3

















Method's and General's
















Took the truck to get aluminum work done a few day's ago. When I get it back I will have the drive shaft built then it should be drive able.





Rendering that was done a few week's ago

[bajascott]

looks great. i always like the sport tracs!

[Nick]

Awesome build! Thanks for posting it up.

[CBDuner]

Holy crap! That thing is awesome!

[AiiRaciing]

Thank's everyone. It's been a very tough build, but it's almost done.

[tcm glx]

Any close up shots of the wheels! I am digging the non beadlock, non simulated beadlock methods.

[AiiRaciing]

Any close up shots of the wheels!

How close are you looking for?

[BajaBronco13]

I have to admit back in the day I never thought the Sport Tracs could be cool, you my friend have changed my mind. Awesome build.

Chris

[damon1272]

I always thought the Sport Trac was a lame vehicle. I make an exceptiopn for this truck. Nice build.

[cwrisley]

Very cool truck. I admit as well I was skeptical when I opened this thread. Its turned out pretty bitchin' so far. Keep it up!!

[AussieRod]

Great build. My question is that I noticed the cage welded to the body in various places, but some of the tubes havent been fitted yet. How were the joins fully welded with the tubes hard against the sheetmetal? Surely none of them are left partially welded? Just curious.

[AiiRaciing]

Great build. My question is that I noticed the cage welded to the body in various places, but some of the tubes havent been fitted yet. How were the joins fully welded with the tubes hard against the sheetmetal? Surely none of them are left partially welded? Just curious.

We cut holes in the cab to get to the top of the cage where the weld couldn't be gotten to from inside. It was a lot more work, a lot more $ and a LOT more time, but its done.












More parts:
Cone Industries 9 inch skid plate



Bad a$$ water cooler holder




Getting rid of the Autorfab hood pins



Only reason I'm posting this is that its been impossible to find, but I finally found one yesterday


Not sure if I'm going to keep this, give it to my brother or sell it as I don't know when I'm going to do a engine/tranny swap

[ChaseTruck754]

Only reason I'm posting this is that its been impossible to find, but I finally found one yesterday

What exactly are you going to use it for? Looks like something Beard or any other strap maker can easily make if they are really that hard to come by...

[philofab]

I get straps that look like that for my tires from buddies at Yesco and Lamar. They are 4 ft long or so. They are used on billboards.

[bajascott]

get a hold of loyd kruse at strapworks. they can make any strop for any purpose. with your name or even your picture screen printed on the nylon. they just got done making some for canadae racing http://www.strapworks.com/Articles.asp?ID=112
sport tracs looks great!!