Page 1 of 2

Brake lines

Posted: Thu Sep 13, 2012 6:58 pm
by hytech450r
Does anyone know if f150 brake lines are the same as bronco?

Re: Brake lines

Posted: Thu Sep 13, 2012 7:01 pm
by hytech450r
2wd

Re: Brake lines

Posted: Thu Sep 13, 2012 7:37 pm
by kylesgorter
The ends are the the same but the 2wd is shorter and the hard line at the.banjo fitting has a different bend. I usually go for crown braided lines never an issue

Re: Brake lines

Posted: Thu Sep 13, 2012 7:46 pm
by hytech450r
Thanks for the info

Re: Brake lines

Posted: Thu Sep 13, 2012 7:51 pm
by hytech450r
I just put 4.5 over beams on my bronco and was hoping the f150 2wd line would work because kartek has 5" over in stock for 2wd f150 and I could just pick them up no wait time but it looks like I may have to wait after all

Re: Brake lines

Posted: Thu Sep 13, 2012 8:21 pm
by hobbyturnedobsession
Go to offroad warehouse. They have all the fragola fittings including the banjo fittings and theyre lines are braided with a teflon coating. I did my fronts for 50 bucks total.

Re: Brake lines

Posted: Thu Sep 13, 2012 8:46 pm
by hytech450r
Orw is in San Diego right?

Re: Brake lines

Posted: Thu Sep 13, 2012 8:49 pm
by hobbyturnedobsession
Depends where you are at. Theres an orw in Temecula that i go to. They had everything i needed in stock.

Re: Brake lines

Posted: Thu Sep 13, 2012 9:25 pm
by hytech450r
Ok that's not as bad as San Diego . I'm near redlands

Re: Brake lines

Posted: Thu Sep 13, 2012 9:29 pm
by hobbyturnedobsession
Im not sure what other cities theyre in you may want to look.

Re: Brake lines

Posted: Thu Sep 13, 2012 9:51 pm
by hytech450r
Alright man thanks again

Re: Brake lines

Posted: Fri Sep 14, 2012 6:00 am
by hobbyturnedobsession
No worries

Re: Brake lines

Posted: Fri Sep 14, 2012 6:41 am
by cs_drums
Where are you located?

Re: Brake lines

Posted: Fri Sep 14, 2012 7:15 am
by hobbyturnedobsession
Me?

Re: Brake lines

Posted: Fri Sep 14, 2012 8:08 am
by crisis88
What's up Sean. Do you know what lenght they need to be? I'm going to have mine made at US Hose.

Jose

Re: Brake lines

Posted: Fri Sep 14, 2012 9:04 am
by ChaseTruck754
Philo turned me onto this place: http://www.allensfasteners.com

They have good prices & all the stuff there too (look in the "AN Fittings" section). They're in AZ I think but I usually get my stuff a day or 2 after I order.


I also have Mesa Hose right down the street from the shop so I get a bunch of stuff there. One thing I like about the lines I get from Mesa Hose vs. the Fragola stuff from Allens is the stainless lines. I can get the "coated" or wrapped ones at Mesa Hose vs. the fragola ones being "bare".

Re: Brake lines

Posted: Fri Sep 14, 2012 9:35 am
by hobbyturnedobsession
Hey Steve orw has those teflon coated lines if you need them too

Re: Brake lines

Posted: Fri Sep 14, 2012 9:39 am
by ChaseTruck754
Good to know. Thanks Randy

Re: Brake lines

Posted: Sat Sep 15, 2012 4:42 pm
by crisis88
does anyone have the measurements of their entended brake lines front and rear?

thanks,
Jose

Re: Brake lines

Posted: Sat Sep 15, 2012 5:31 pm
by hobbyturnedobsession
I van get em for you tomorrow Jose