As the title states, did John close his doors. Drive by every day for work and looks like the spot has been cleared out.

Well worth buying a set. Very well made.

Tires sold

Steering system and ported steering box sold.

All prices are OBO - will combine for a better price. +3 autofab TTB beams, radius arms, axles, and brackets -$2950 Richer Racing shock towers for 80-96 f150/bronco -$1000 Bilstein 14” c/o shocks w/acv valves - $950 +3 swinger steering, homes, and pitman arm Southwest Performance $1050 (can be cut d...

ocfab.com is his web site

Interesting. Cho’s runs straight tie rods as it looks like he ran the linkage out a touch further so as not to have a bend. Not sure that he I’m will completely remove the bend but it would make it slightly less.

The trans is availed. It is stock. Located in San Diego.

Fox shocks - unboxed for pictures. Never installed. Will ship your dime. 2-2.5x14 “ coil over dsc adj. comp/rebound 38.5 ext. 24.5 compressed. $2000 obo 2-2.5x16” coil over dsc adj. comp/rebound 45” ext 29” compressed $2000 obo 3x16” 4 tube bypass 42.5 ext. 26.5 compressed $3000 obo 2- 3x18” 5 tube ...

Contact Hollander. He has a line on new steering boxes that would be worth looking into.

I wonder what the apmerage draw that compressor would be? Otherwise it would be a good alternative.

You have 3 left now.

Stock tank and skid plate. Good shape. Free.

NOS small block C6 with torque converter 4x transmission. Still has the factory tags and plugs. Sat on a shelf for years.
$1850 obo located in San Diego.
Contact for pics

Also looking to trade van 9” axle housing and axles for a truck axle housing and axles.

15 ton press. Hydraulics leak but still works. Needs the ram rebuilt. It is an old Jet press. Located in Ramona must pick up.

Personally would do a hydraulically balanced lift so you don’t have to run a cross bar. I have a Mohawk 12 k lift. One of the best lifts I have used. Much better than a twin ram in floor lift or a cheaper cross bar with chain. Also stay with a symmetrical lift arms. Much easier to use with shorter w...

I may be able to give you a hand. Do you have the bearings and everything or just the gears?

Why don't they install a rivet rather than the internal stops. Much easier to modify or fix.

Boy did auto correct get me or what. The Tapco's and hex mag are a hard pass. P mags are good to go. We recently had freedom week here in CA and mag restriction were lifted for a week. It is estimated that over a million mags made it into California in that week when the law was nullified. I feel fo...

Anyone have any REAL world experience with Hexmags? Good/Bad/indifferent? Apparently I can buy these here in Victoria without a licence, according to the supplier, but at 9 TIMES the cost you guys pay for them. Just curious if they are as good as the benchmark Pmags. Rod, Hex mag and taco's are a h...