definitely will let you guy stay the experts here lol

I just acquired a manual tranfer case today

good deal

Agui-E7TE wrote:And make sure you keep oil in it other wise it wont shift and then 200 miles later it'll let go.. ask me how I know

Im hoping my local Junkyard has one for me to trade for

mkiefer wrote:the 8.8 dosent need a carrier. Unless you want a locker

I wont need a carrier even with the ford factory limited slip?

There are several great manufacturers.....we deal with Nitro gear and axle and yukon primarily. I dont recomend you attempt to set your gears up unless you have someone that knows how to do it. You will also need a new carrier for both the 8.8 and the D44 as well as master install kits. Usually you...

glad my buddy steered me to this site.

So I assume you have a pushbutton 4x4 BW1356 T-case. If the motor is switching it from 2 hi to 4 hi and not to 4 low, it might have internal problems or the SOTF computer might not be working or their could be a short in the harness. I would start by hitting the motor while someone shifts it into 4...

I have my 88 bronco I just picked up and as I was out playing around I found I couldnt get it to switch into 4L. It will go back and forth from 4h to 2h without issue but when trying to get it to go from 4h to 4L its not happening the light just continues to flash. I tried it from a 100% stop, from ...

What gears would be recommended for a 95 351 with a e4od and 37's? Sent from my T-Mobile G1 using Tapatalk 4.88s.....5.13 you start losing strength in the pinion. For a real world I went to 4.88s with 33's and it was tolerable with the e4od you just had to limit freeway speed to about 65ish but gre...

thanks again guys.... i keep learning more and more daily

well after a little more research my bronco has OD..... its OD, D and 1st

Well...you're '88 has a C6 non-overdrive trans so you may want to back the gearing down a bit...4.88s with 35s and no overdrive means your engine will be spinning at 3200 rpm at 70mph...4.10s would probably be enough If you aren't familiar with changing gears I would suggest a shop near you set the...

On I have an 88 bronco with 351W in her. I am going to be putting on a 4" suspension lift here shortly and will also be doing new tires. Where I am stuck at is deciding tire size and gearing. I figured I would wait till the lift was on it to see if I want to go with 33's or 35's. At the moment I am ...

After much more research and a lot of testing I am keeping the ttb front end. Gunna lift her and set up my tires.

I just recently acquired an 88 bronco and am going to try and build this thing up piece by piece. I am a desert rat so who knows how I will end up. My name is Gene and I heard about this forum from one of its members who told me this is the place to be if you wanna know about REAL BRONCOS. So here I...