Well little update, Betty has a new heart. 408w, edelbrock heads, comp roller cam, edelbrock rpm air gap intake. Going to be running a Holley sniper efi and a (Thanks to Matt) US shifts quick 4 trans controller. https://uploads.tapatalk-cdn.com/20181029/3e39ce3f2582479954d12bb4fa3b685f.jpg Sent from...

Anybody interested in a Moates quarterhorse chip? Its the newer version with the replaceable battery. Since I'm getting rid of all the factory efi stuff I won't be using it. I sale it for $175 shipped I also have everything to swap to Mass air including the air tubes and a Amsoil filter with prefilt...

Thanks Matt, I'll put it to good use

Sent from my SM-G960U using Tapatalk

Does this have the early or late connectors?

Spacers are another way you could go.

Offers?

Sent from my SM-G960U using Tapatalk

I had these custom made for my bronco a few months back then ended up having a new rear axle built. The measurements are: Flange side inner bore 73mm, outer bore is 98.73mm (Fits 9" axle flange with 89 bronco front rotors) Wheel side 85.71mm (Fits in the center bore of factory Alcoas) These are dril...

Well after about 3.5 years, a lot of money, a very understanding wife, and three wrist surgeries that have rendered my left hand pretty much useless she's back on the road. Still have some sms stuff to finish up but she's drivable. https://uploads.tapatalk-cdn.com/20170430/b94bb1a4c3821786467648a1da...

I'm currently running a 5.0 ecu on a 5.8 with no issues.

E4OD is in, and she runs. Been over two years since I last started it, hit the key and she came to life. Next on the list is the installation of the punisher and the winters shifter.

Little update, dash is in, ZF is out. Since I decided to go back to the e4od I had to remove the MAF conversion kit I had on it. Luckily for me the truck I got the trans out of was a MAF truck so I pulled the intake hoses, sensor and computer. Then the fun part of re-pinning the 60 pin connector, ru...

I was contemplating trying that exact same set up on my steering.

Sold sold sold!!!

I really need this gone asap, $375 shipped.

Gauging interest in this kit. I ran this for a little while before I tore into the bronco. Worked great, but since it looks like I'm going back to a E4OD trans I won't be using it anymore. Will come with: A3M computer(mustang 5.0 manual trans) Fuel injector overlay harness Y adapter Mass air meter T...

Sold!!!

Just a suggestion but check your cats. I had a similar issue a few years ago with mine. It would start losing power, sputtering and wouldn't idle. This would happen after running it hard, if I let it sit for an hour or so it would run fine. Again just throwing an idea out there.

Your welcome. I'll try to snap some pictures of my mounts in the next couple of days.

If this link works it talks about using the factory sliders with suspension seats.
http://www.gofastbroncos.com/forum/viewtopic.php?t=7421

I have a complete dash wiring harness from a 95 f-150 in great shape no cut wires. I'll get some pictures up tomorrow. $75.00 shipped.