Does anyone have a 7 degree reamer they can lend me for a weekend?
I did the "knuckle under" TRE flip a few years back, and my driver side knuckle was reamed just a hair to much. After swapping out the steering box, and new moog TRE's, thats the only play left in the steering. I want to ream it deeper and use the conical steel inserts to get it right. Looked around online and they are $100+. Id be happy to throw some money in paypal and cover shipping.
7 Degree Reamer
-
- Posts: 125
- Joined: Fri Apr 02, 2010 5:30 pm
- Bronco Info: 82..... 302ho
- Wrightracing.net
- Posts: 2214
- Joined: Thu Oct 28, 2010 9:58 pm
- Bronco Info: 1972 Bronco with an 86 chassis, full cage and Long travel coil-over suspension.
- Location: San Diego
- Contact:
Re: 7 Degree Reamer
I'd the Dana 44 lower ball joint hole 7 degrees. In the past I did the cut and turn buy reusing the cut one and moving it out. I am going to make a bullet steel one piece lower mount. I keep seeing two angles 7 and 10.
I am going to get a reamer.
David
I am going to get a reamer.
David