Page 1 of 1
Driveshaft questions ?
Posted: Mon Jan 15, 2018 4:50 pm
by wookiee156
Hey doodes my driveshaft is toast and I cannot seem to decide what to do as far as rebuilding or buying a new one from Jeff’s as I’m easily confused and well thought I should get the gfb community’s opinion.?? Hopefully this is not a subject that’s been beaten to death. If someone has a link to a thread that I couldn’t find thanks
Thanks again
Re: Driveshaft questions ?
Posted: Tue Jan 16, 2018 3:22 pm
by PaulW
Today I bought all the rebuild parts for a shaft on another rig. $106 for the CV Ball kit and $13 for each of the 3 U-joints. Al lot less expense compared to a new shaft from a vendor. My slip joint was good. Take the old part with you or get the part numbers from one of the vendors or here on this forum from one of the guys.
Re: Driveshaft questions ?
Posted: Wed Jan 17, 2018 11:17 am
by wookiee156
Thanks I was kinda thinking the same thing I don’t think I can make it much worse
Re: Driveshaft questions ?
Posted: Tue Feb 06, 2018 1:35 pm
by wookiee156
PaulW wrote:Today I bought all the rebuild parts for a shaft on another rig. $106 for the CV Ball kit and $13 for each of the 3 U-joints. Al lot less expense compared to a new shaft from a vendor. My slip joint was good. Take the old part with you or get the part numbers from one of the vendors or here on this forum from one of the guys.
I just wanted to post I picked up a rebuild kit from Jeff’s for $75 (3 joints and the peice that goes in the cardigan) plus $8 for ubolts It only took a week to ship so hopefully this might help someone else with the same problem