FANCY

Post Reply
User avatar
Wrightracing.net
Posts: 2205
Joined: Thu Oct 28, 2010 9:58 pm
Bronco Info: 1972 Bronco with an 86 chassis, full cage and Long travel coil-over suspension.
Location: San Diego
Contact:
Contact Wrightracing.net

Post by Wrightracing.net »

I just priced semi floater custom axles at Dutchman at $460 with 5/8 circle track studs and all the bearings, seals and retainer plates installed. The width was up to 34" per side putting the axle more than 68" wide. And only a few bucks more to go even wider.
Top
cs_drums
Posts: 2912
Joined: Wed Dec 22, 2010 10:39 am
Bronco Info: 94 5.8 Bronco w/dreams of being finished

FANCY

Post by cs_drums »

Bumped into the Whiterhino himself! Knew that driveway looked farmiliar... It's a block from my house. Looking good!
Image
Top
VintageIronFab
Posts: 2328
Joined: Mon May 27, 2013 12:25 am
Bronco Info: Bronco List:
Location: Phoenix, AZ

Re: FANCY

Post by VintageIronFab »

Hunt the net--35 spline axles are not too far off cost wise. Differential parts are literally the same cost today as they were 15 years ago. You do run into the suggested retail price guys that are trying to whack your guts out! Make sure you peruse eBay as many sellers on there have phone numbers that you can call and get even better deals direct.
Top
Post Reply

Return to “Big Broncos”