Steel Spinning Shooting Targets

[Kel Fab Creations]

These are designed to be shot at with a 22 caliber rifle or handgun. Stake anything in the ground with an inside round hole on the top measuring 3/4". Slip the target into the hole and you're ready for shooting practice. Example picture shows a piece of 1"x.120 round tubing welded to the back of 2"x2" angle iron. Make your own stand with scraps you have laying around or I can make a stand for an additional charge.

[FUFIMI]

how much for one with a stand?

[Kel Fab Creations]

how much for one with a stand?

What kind of stand would you like? Angle iron like the pic? How tall? How many targets would you like it to hold?

[FUFIMI]

4 targets with an angle iron stand about 3 to 3 1/2 feet tall would be good. thanks kel

[Kel Fab Creations]

So 4 targets and a stand that holds one at a time? Or did you want all 4 targets on the stand?

[FUFIMI]

1 target with 4 octagons, so only one and one stand. Sorry about the the confusion

[Kel Fab Creations]

45 for the stand and one target. The stand will be 4ft long so you can have a foot in the ground.

[FUFIMI]

Ok if one is ready, I can go pick it up on Tuesday

[Kel Fab Creations]

I have a few targets ready to go. I'll try to get the stand done tonight or tomorrow. I'll send you a text when its done.

[FUFIMI]

Awesome thanks kel

[FUFIMI]

Great product, can't wait to go out and use it. Thanks Kel

[Wrightracing.net]

Nice Target Design. I have made a couple swinging targets for my 5.556 rifle.

[Wrightracing.net]

Nice Target Design. I have made a couple swinging targets for my 5.556 rifle.

5.56 rifle Edit needed!