Bronco and Fort truck parts

[philofab]

I’m consolidating / cleaning up, so here is a list of stuff I’m selling off:


80-83 Dana 44 TTB Complete beams/axles/brakes/hubs (bolt on axle 3rd) $500

84 Dana 44 TTB complete beams/axles/brakes/hubs (hubs have damaged selector knobs) (regular 3rd) $300

Dana 44 TTB bare stock beams $200

C6 Diesel transmission, 4wd, with rare VSV valve. Rebuilt. $500

C6 Diesel trans, 4wd, unknown internal condition, $200

C6 Diesel trans, 2wd, missing tailshaft housing, slips in all gears. $100

C6 SBF trans, 4wd, unknown internal condition, $200

NP208 Ford fixed yoke T cases 31 spline input (Bronco specific but will work on whatever) $100 each

1971 F100 9” rear axle complete. 28 spline, 5x5.5 61.25” width. 1957-72 are all same width. This is a light duty housing. $200

1984 Bronco 9” rear axle complete. 31 spline, 3.50 gears, 5x5.5 65.25” width. 78-85 are all same width. This is a heavy duty housing. $250

4.88 9” Center section with Detroit locker. 1330 yoke, OE non nodular case. $500

Yokohama/Ironman 285/70/17 (2 each, look identical) Two are 90% tread, other two are 60% tread. $300 for 4.

71 F100 short bed roller. No engine or trans. Bed in good shape. Cab has normal rust in drip rails. $3000

74 F100 short bed regular cab. 514 BBF, C6, EFI, All new rubber and parts. Needs details and paint finished (90% done). $11,500


Also parting a few trucks right now: 66 F250 long bed, 86 F250 LB Extra Cab 6.9 Diesel 4x4, 84 Bronco 4x4 C6 SBF V8


All parts are located in Mohave Valley, AZ, 86440. Text or email me for fastest response. 928-201 five eight eight nine or philo at mohavebattery.com

[biggiek]

Damn wish I saw the 9 inch before rebuilding my 8.8

[philofab]

9” Bronco rear end and 4.86 third member sold.