Page 1 of 1
Built 8.8
Posted: Wed Jan 31, 2018 10:37 pm
by Tchajagos
I have a built 8.8 for sale. Decided To go another route. Came out of a 95 bronco. Has 4.56 gears and a Detroit locker. Also has a mag-hytec diff cover which has a little dipstick out the top. 5/8” wheels studs and a truss under the bottom and limit strap tabs off the back. The perches have been re-welded to eliminate the wedge blocks. It has maybe 400 miles on new gears/locker/rebuild. Everything is in great condition. Bolt it in, bleed the brakes, and drive off into the desert. Looking to get $1100.
Just a regear and a locker are more than that. Located in riverside. Text me (951)452-4050.
Re: Built 8.8
Posted: Thu Feb 01, 2018 7:29 am
by 1Hondalover
Sorry I don't text buddy. If this was 4.11 it may be in my hands already. Did you fab the truss and degree the pads?
Built 8.8
Posted: Thu Feb 01, 2018 9:15 am
by Tchajagos
All done by solo
Built 8.8
Posted: Fri Feb 02, 2018 8:13 pm
by Tchajagos
Bump. If you can’t use 5/8” studs you can always swap out your inner axles and keep the 5/8” stud axles for when you move up to the larger wheel studs.
Built 8.8
Posted: Sun Feb 04, 2018 12:11 pm
by Tchajagos
$900 without the rear cover.
Built 8.8
Posted: Sun Feb 04, 2018 12:16 pm
by Tchajagos
I also might have a set of 1/2” stud axles I can throw into the housing instead of the 5/8” studs.
Built 8.8
Posted: Wed Feb 07, 2018 10:21 am
by Tchajagos
Bump
Built 8.8
Posted: Wed Feb 07, 2018 3:25 pm
by Tchajagos
Turns out this rear axle was fabricated by southwest. A bronco just came in that was built by southwest and it has the exact same truss and traction bar tabs.
Posted: Sat Jul 21, 2018 11:24 am
by robertcrav
Did this sell?
Sent from my SM-G950U using Tapatalk
Built 8.8
Posted: Sun Jul 22, 2018 1:53 am
by Tchajagos
robertcrav wrote:Did this sell?
Sent from my SM-G950U using Tapatalk
Yes I did. Sorry
