Narrowed dana 60/ corp 14 bolt vs 9"
- ChaseTruck754
- Spy/Ninja
- Posts: 9194
- Joined: Thu Jan 28, 2010 9:46 am
- Bronco Info: Don't have one - just old Ford trucks
- Location: Huntington Beach, CA
Re: Narrowed dana 60/ corp 14 bolt vs 9"
damn. Had I known that when I was looking at the rear ends for the crew cab I would have possibly gone 10.25 vs. having my hubs machined on the 10.5. Oh well.
- Wrightracing.net
- Posts: 2214
- Joined: Thu Oct 28, 2010 9:58 pm
- Bronco Info: 1972 Bronco with an 86 chassis, full cage and Long travel coil-over suspension.
- Location: San Diego
- Contact:
Re: Narrowed dana 60/ corp 14 bolt vs 9"
I know this is a old thread, but I can't sleep and bored.
Has anyone used a 08 F350 rear axle. I found a deal on one from a gas truck with 4.10 gears and the factory e-locker for $650 +$150 shipping. It has a 123k miles. I have read on other forums the 05+ axles were better with 35 spline axles and around 69" wms to wms. I know it will be heavy compared to my 9in, but it would give me 4in wider, 35 spline, full floater, 4.10 as my front for now and a E-Locker.
I don't know much about the OEM lockers, are the ok. I have only had Detroit Locker and never had a issue and I like how the run on Sand and I just don't accelerate in corners to keep from chirping the tires. I have an ARB air locker for the front, but I hate the idea of looking air pressure from a air leak when I really need it. Of course the air compressor or air line will fail when I really needed it
I think too much and it would be a quicker solution than a $4000+ fabricated 9". Weight is an issue, but how much?
I can get in the dirt faster and put money somewhere else on the Bronco.
Just thinking out loud or atleast the editted version with less 4 letter words
David
Has anyone used a 08 F350 rear axle. I found a deal on one from a gas truck with 4.10 gears and the factory e-locker for $650 +$150 shipping. It has a 123k miles. I have read on other forums the 05+ axles were better with 35 spline axles and around 69" wms to wms. I know it will be heavy compared to my 9in, but it would give me 4in wider, 35 spline, full floater, 4.10 as my front for now and a E-Locker.
I don't know much about the OEM lockers, are the ok. I have only had Detroit Locker and never had a issue and I like how the run on Sand and I just don't accelerate in corners to keep from chirping the tires. I have an ARB air locker for the front, but I hate the idea of looking air pressure from a air leak when I really need it. Of course the air compressor or air line will fail when I really needed it
I think too much and it would be a quicker solution than a $4000+ fabricated 9". Weight is an issue, but how much?
I can get in the dirt faster and put money somewhere else on the Bronco.
Just thinking out loud or atleast the editted version with less 4 letter words
David