TTB Dana 44 internal components compatibility

thangtamfive
Posts: 1
Joined: Wed Jul 26, 2017 8:13 pm
Bronco Info: no activation

TTB Dana 44 internal components compatibility

Post by thangtamfive »

I was wondering if the internal diff and gears from a 1986 Bronco Dana 44 fit in a 1981 bolt on axle housing?
LvSteve
Posts: 320
Joined: Sun Jul 14, 2013 8:02 am
Bronco Info: 1995 XLT Sport. 96 427w e4od obd II system........ SOLD IT
Location: Henderson NV , Murray UT

Re: TTB Dana 44 internal components compatibility

Post by LvSteve »

Yes if we are talking about TTB parts
User avatar
Tchajagos
Posts: 2124
Joined: Sat Dec 17, 2011 11:07 am
Bronco Info: 1993 xlt stock on 33' BFGs
Location: Murrieta

TTB Dana 44 internal components compatibility

Post by Tchajagos »

Yes but if you are regearing to over 4.00 numerically you will have to get a different carrier. You will have to setup the new housing with shins to get the pattern back because no housing is the same. If you are going through all that why not just put in new bearings while your at it? Pretty much the only thing I reuse when regearing a Dana 44 are the spider gears/pin and housing.
Post Reply