Superduty Knuckle on a Dana 50 TTB
Posted: Sun Dec 31, 2023 8:15 pm
I was wondering if anyone has put a unit bearing knuckle from a F350 to a Dana 50 TTB front axle. I have a 1999 f350 and I like the automatic hub lock, but it still has a manual lock on the hubs.
I have Dana 50 beam ends, but I have not welded them in yet. I was wondering if the Superduty knuckles would bolt up to the Dana 50 beams.
I do want to see if a beam end on the Straight axle could be grafted to the TTB beam.
I was looking for Knuckles for the 95-97 F250 and they are hard to find complete and expensive to buy part by part.
What are your thoughts.
David
I have Dana 50 beam ends, but I have not welded them in yet. I was wondering if the Superduty knuckles would bolt up to the Dana 50 beams.
I do want to see if a beam end on the Straight axle could be grafted to the TTB beam.
I was looking for Knuckles for the 95-97 F250 and they are hard to find complete and expensive to buy part by part.
What are your thoughts.
David