Driver Side Axle Shaft

Post Reply
User avatar
Tchajagos
Posts: 2124
Joined: Sat Dec 17, 2011 11:07 am
Bronco Info: 1993 xlt stock on 33' BFGs
Location: Murrieta

Driver Side Axle Shaft

Post by Tchajagos »

The ball joint spacing is the same on all years. The differences were the spindles (5/6 bolt and bearings) and brake calipers/caliper ears.
Top
biggiek
Posts: 549
Joined: Sun Aug 24, 2014 12:27 pm
Bronco Info: 92 Ford Bronco

Re: Driver Side Axle Shaft

Post by biggiek »

It seems like the c and t was done bad after all the ear/c channel opening is 3/8 inch narrower than needed.
Top
User avatar
Wrightracing.net
Posts: 2225
Joined: Thu Oct 28, 2010 9:58 pm
Bronco Info: 1972 Bronco with an 86 chassis, full cage and Long travel coil-over suspension.
Location: San Diego
Contact:
Contact Wrightracing.net

Post by Wrightracing.net »

When I did my beams, I had the knuckle bolted in place to make sure that exact issue was not a problem.
Top
Post Reply

Return to “General Tech”