Who was making fabricated core supports.

Jbfab · Post by **Jbfab** » Fri Mar 06, 2015 6:41 pm

There was a fella floating around that made fabricated core supports. I think yogi gave me his info a few years ago but that is long gone. Anyone know how to get ahold of that person? Thanks in advance.

philofab · Post by **philofab** » Fri Mar 06, 2015 8:04 pm

Charlie Forman

Jbfab · Post by **Jbfab** » Sat Mar 07, 2015 7:25 pm

philofab wrote:Charlie Forman

Is he on here? Or do you happen to know his email address?

ChaseTruck754 · Post by **ChaseTruck754** » Sat Mar 07, 2015 9:01 pm

not on here I don't think. Pretty sure this is him
https://www.facebook.com/charlie.foreman.10

shockseals.com · Post by **shockseals.com** » Mon Mar 09, 2015 2:05 pm

I had a core support from Charlies personal bronco...If he was going to make it to that standard I would bet there is 40+ hours of high end craftsmanship into it. Those that don't know Charlie Foreman he is very high end fab/prep guy. Catching him on facebook is easiest. I talked to him about a month ago. If youre not looking to spend a couple grand I wouldn't think Charlie is the guy.

Jbfab · Post by **Jbfab** » Mon Mar 09, 2015 2:27 pm

Iirc the guy yogi gave me the info of quoted me $450 with tabs for the header panel only. If it gets to be to out of hand ill just make my own.