Are you sure it’s the shocks maxing out and not the springs? Can you measure the shaft length at ride height and at full droop?

Raptor shocks


Gen 1

18" collapsed
29-1/2" extended

11-1/2" stroke


Gen 2 shocks

18-3/4” collapsed
31” extended

12-1/4” stroke


King shocks

Resi bypass 12”

20.625” collapsed
32.625” extended

12” stroke

I just put a new dash bezel, new window, and new led lights in the gauges and it’s like a new truck. Highly recommended for everyone haha.

Another tidbit for D50 lovers. If you want to run a Trutrac or other diff not available for D50's, it's easy peasy. DTS in Michigan has adapter sleeves that press on a D44 carrier and adapt it to D50 carrier bearings. The ring gear one has a shoulder to move the carrier over for correct alignment. ...

What was the fuel pressure at the rail?

Is this for a standard case or 3.250 case?

I’m going. Are they going to have the trophy trucks again on Thursday?

I have 1 (951)452-4050

Any reason you can't just get 91-94 bearing and seal set? Are there differences inside the hub as well? I suppose worst case you'd have to swap the hub out or bearing races to make it work properly. Seems a lot safer than a custom fit spacer. The bearing spread inside the hub is slightly shorter on...

I’ll take that trans/xfer case. Looking to put a 460 in instead.

In stock location, with 4” lift and cut/turns, 10” pin tops in front of beams, 8” pin tops behind beams. Fox has 2.0 pin tops. You will have to make the lower mounts pretty low for the rear of beam shocks. Even with 8s. You will still get like 11” of travel.

I have some for you.

Just pulled it out for you.



I’m in Colton but drive to LA for work during the week. Let me know if you need it still. Message me at (951)452-4050

I have a set of factory alcoas. 15” 5x5.5. In good condition. Looking to get $300 for the set of 4. Just have some dust on them in the pic. Strip the clear coat and they will be super polished underneath. https://uploads.tapatalk-cdn.com/20191003/d66f05f67e6b8da7568d2e1ef2dd2d3c.jpg I also have a se...

Oct 19-20th

biggiek wrote:Good to know...

I have one for you but it’s buried in my storage unit. I’ll try to dig it out this weekend.

It kind of depends on the tires size and engine power too. 37s and big power you will want 35 spline. Stock motor and 35s, 31 spline should be fine. A spool is great for offroad. If you plan on any on-road driving a spool is kind of a pain. Do the explorer brakes just bolt on the ends or what? I don...

Sold. That was fast.

Picked this up not too long ago. Ended up getting a 4 door instead. 1997 F250HD 4x4 with a strong 460 7.5l motor and auto trans. Extended cab long bed. Has a 6” lift but I sold the old wheels and tires. Has 300xxx on the odometer but motor and trans were rebuilt about 50k ago I was told. Come with a...

Sorry, spotlight 29. Not searchlight. That’s a town in NV.