Search found 1957 matches
- Tue Feb 25, 2020 12:18 pm
- Forum: Tech
- Topic: Deaver j40 with 12” shock
- Replies: 5
- Views: 3988
Deaver j40 with 12” shock
Are you sure it’s the shocks maxing out and not the springs? Can you measure the shaft length at ride height and at full droop?
- Tue Feb 25, 2020 12:16 pm
- Forum: Tech
- Topic: Deaver j40 with 12” shock
- Replies: 5
- Views: 3988
Deaver j40 with 12” shock
Raptor shocks
Gen 1
18" collapsed
29-1/2" extended
11-1/2" stroke
Gen 2 shocks
18-3/4” collapsed
31” extended
12-1/4” stroke
King shocks
Resi bypass 12”
20.625” collapsed
32.625” extended
12” stroke
Gen 1
18" collapsed
29-1/2" extended
11-1/2" stroke
Gen 2 shocks
18-3/4” collapsed
31” extended
12-1/4” stroke
King shocks
Resi bypass 12”
20.625” collapsed
32.625” extended
12” stroke
- Wed Feb 12, 2020 7:16 pm
- Forum: Non-Broncos
- Topic: The Motley Crue: White '97 OBS Crew Cab Build
- Replies: 195
- Views: 30172
The Motley Crue: White '97 OBS Crew Cab Build
I just put a new dash bezel, new window, and new led lights in the gauges and it’s like a new truck. Highly recommended for everyone haha.
- Mon Jan 27, 2020 10:24 pm
- Forum: Go-Fast Tech
- Topic: D 50 misc
- Replies: 12
- Views: 1996
D 50 misc
Another tidbit for D50 lovers. If you want to run a Trutrac or other diff not available for D50's, it's easy peasy. DTS in Michigan has adapter sleeves that press on a D44 carrier and adapt it to D50 carrier bearings. The ring gear one has a shoulder to move the carrier over for correct alignment. ...
- Mon Jan 27, 2020 10:18 pm
- Forum: General Tech
- Topic: 1992 Bronco Dies
- Replies: 10
- Views: 1436
1992 Bronco Dies
What was the fuel pressure at the rail?
- Wed Jan 22, 2020 8:35 am
- Forum: Parts
- Topic: 9" Detroit Locker 35 spline
- Replies: 3
- Views: 383
9" Detroit Locker 35 spline
Is this for a standard case or 3.250 case?
- Tue Jan 14, 2020 12:10 pm
- Forum: Event Planning
- Topic: King of the Hammers 2020
- Replies: 28
- Views: 8948
King of the Hammers 2020
I’m going. Are they going to have the trophy trucks again on Thursday?
- Fri Dec 27, 2019 9:00 pm
- Forum: Wanted
- Topic: Bolt-On TTB Differential
- Replies: 2
- Views: 1013
Bolt-On TTB Differential
I have 1 (951)452-4050
- Mon Dec 02, 2019 4:55 pm
- Forum: Tech
- Topic: 96 spindles
- Replies: 16
- Views: 6065
96 spindles
Any reason you can't just get 91-94 bearing and seal set? Are there differences inside the hub as well? I suppose worst case you'd have to swap the hub out or bearing races to make it work properly. Seems a lot safer than a custom fit spacer. The bearing spread inside the hub is slightly shorter on...
- Wed Oct 30, 2019 10:21 pm
- Forum: Parts
- Topic: 400m and c6 and Tcase
- Replies: 2
- Views: 240
400m and c6 and Tcase
I’ll take that trans/xfer case. Looking to put a 460 in instead.
- Wed Oct 23, 2019 10:08 pm
- Forum: Go-Fast Tech
- Topic: Coil with shock options
- Replies: 3
- Views: 1481
Coil with shock options
In stock location, with 4” lift and cut/turns, 10” pin tops in front of beams, 8” pin tops behind beams. Fox has 2.0 pin tops. You will have to make the lower mounts pretty low for the rear of beam shocks. Even with 8s. You will still get like 11” of travel.
- Tue Oct 22, 2019 5:30 pm
- Forum: Wanted
- Topic: Wanted - Stock Coil Springs
- Replies: 6
- Views: 1545
Wanted - Stock Coil Springs
I have some for you.
- Sun Oct 06, 2019 11:17 am
- Forum: Wanted
- Topic: Wtb hood latch cable
- Replies: 9
- Views: 1246
Wtb hood latch cable
Just pulled it out for you.
I’m in Colton but drive to LA for work during the week. Let me know if you need it still. Message me at (951)452-4050
I’m in Colton but drive to LA for work during the week. Let me know if you need it still. Message me at (951)452-4050
- Wed Oct 02, 2019 8:13 pm
- Forum: Parts
- Topic: Alcoas 15” and 16”
- Replies: 0
- Views: 358
Alcoas 15” and 16”
I have a set of factory alcoas. 15” 5x5.5. In good condition. Looking to get $300 for the set of 4. Just have some dust on them in the pic. Strip the clear coat and they will be super polished underneath. https://uploads.tapatalk-cdn.com/20191003/d66f05f67e6b8da7568d2e1ef2dd2d3c.jpg I also have a se...
- Wed Oct 02, 2019 8:04 pm
- Forum: Event Planning
- Topic: Leduic swap meet????
- Replies: 31
- Views: 10459
Leduic swap meet????
Oct 19-20th
- Wed Oct 02, 2019 8:03 pm
- Forum: Wanted
- Topic: Wtb hood latch cable
- Replies: 9
- Views: 1246
Wtb hood latch cable
I have one for you but it’s buried in my storage unit. I’ll try to dig it out this weekend.biggiek wrote:Good to know...
- Sun Sep 22, 2019 4:18 pm
- Forum: Go-Fast Tech
- Topic: 31 or 35 Spline - Detroit or Spool??
- Replies: 10
- Views: 1992
31 or 35 Spline - Detroit or Spool??
It kind of depends on the tires size and engine power too. 37s and big power you will want 35 spline. Stock motor and 35s, 31 spline should be fine. A spool is great for offroad. If you plan on any on-road driving a spool is kind of a pain. Do the explorer brakes just bolt on the ends or what? I don...
- Wed Sep 18, 2019 7:12 am
- Forum: Vehicles
- Topic: 1997 F250HD 4x4 460
- Replies: 2
- Views: 1495
1997 F250HD 4x4 460
Sold. That was fast.
- Tue Sep 17, 2019 10:45 am
- Forum: Vehicles
- Topic: 1997 F250HD 4x4 460
- Replies: 2
- Views: 1495
1997 F250HD 4x4 460
Picked this up not too long ago. Ended up getting a 4 door instead. 1997 F250HD 4x4 with a strong 460 7.5l motor and auto trans. Extended cab long bed. Has a 6” lift but I sold the old wheels and tires. Has 300xxx on the odometer but motor and trans were rebuilt about 50k ago I was told. Come with a...
- Wed Sep 11, 2019 8:02 pm
- Forum: Event Planning
- Topic: Leduic swap meet????
- Replies: 31
- Views: 10459
Leduic swap meet????
Sorry, spotlight 29. Not searchlight. That’s a town in NV.