So with solos 4link it being so easy, I’m thinking about doing it. Was planning on taking the shocks through the floor and I’d be doing nearly the same work as it will be to link it lol. Looking for some opinions on stretched vs non stretched broncos. Solo is also coming out with their stretch kit w...

Now that you say that, I remember Paul at Solo telling me that’s what he did. I’m going to have to do some research on that! Because I don’t know what all is required to make that happen

Need some opinions I’m running 4.5” beams from Solo with their drop down pitman arm and tie rod extensions Been using them for about 4 years now with some decent hard miles on them. Do I need to upgrade to a dual swing steering with heims for safety reasons? Should I be concerned about breaking tie ...

Okay good to know! Thanks!

Trans temp question


Installing a cbr cooler with an external filter. I’m getting a moroso external filter mount with a gauge port.
So my gauge will be before the cooler, what trans temp to hot? I saw some people saying 170 is normal and don’t go over 220

SOLD

Sent*

Send you a message!

Yukon 4.56 ring and pinion out of the front of my 95
They were put in about 3 years ago when the truck was first built and have minimal use as I really don't use 4x4 much.
$150 yes I will ship on your dime
Only reason for taking them out is I changed gear ratio

Oh cool I didn't know there was a fix for that. And yeah again thanks!!! As far as what I used was a 1997 master cylinderpart number MCA390337 (carquest part number) The reason for that is it comes with. Disk disk proportioning valve I have not installed the 2 lb residual valves that have been recom...

Thanks photo bucket for ruining my entire thread hahaha. But some upgrades got made to the bronco. Maybe this rear end will actually last https://i.imgur.com/FW05xoB.jpg https://i.imgur.com/G2zesYH.jpg https://i.imgur.com/SgqOnGp.jpg https://i.imgur.com/CAJNcTH.jpg https://i.imgur.com/WMjK1Ky.jpg ht...

$1000 for 3rd member
$400 for axles obo

Oh alsoooo I have a pair of 2" wheel spacers. $40

$1100 for the 3rd member
$450 for the axles

So I am going to buy a 40 spline full floater Currie rear end so I'm selling my 3rd member and axles that have less than 100 miles on them It's a Yukon nodular iron 3.25 case 4.56 gears Spool Billet steel pinion support Billet steel 1350 yoke Timken USA bearings And 35 spline Currie axles for a stoc...

Well the new rear end lasted a whole 2 months... I guess it's time I finally buy a Currie. So now I just need to decide if I want to link the truck or not. Because if I'm spending this much on a rear end it's either I link it now or I never do. http://i1364.photobucket.com/albums/r738/tanner287/bron...

So the bronco is finally back up and running. The spool is pretty fun on the street lol http://i1364.photobucket.com/albums/r738/tanner287/bronco/B4EEEADE-7B4B-432F-8B1D-1C0102A184A7_zpsj2rhsyvf.jpg http://i1364.photobucket.com/albums/r738/tanner287/bronco/02D621B6-8396-4554-9CCC-5CD529478066_zpsheg...

Only have the one stock driver side axle left!

They are Yukon if I remember correct, and yes I would be willing to ship to wherever!