I have a pair of brake rotors: 5 on 5.5, 11.66" diameter, drilled for 5/8 studs, rotor width: 1.25" offset: 1.35", Pilot bore: 4.285" I had them nickel plate so they won't rust

$60 will ship

sold, thanks GFB

sold, thanks GFB

8.8 trick flow rear diff cover, $20 plus shipping

bump, still got these, text me if you want them 619-247-4541

check drivers beam bump with axles in, I notched my drivers side bottom frame rail to get more up travel but the cross over U joint hits on the bottom of the passenger beam pivot. Also kick ass build!

I have a set of dana 44 stock beam cores, located in San Jose, 50$

sold

new extended front brake lines, mocked these up but routing made coil pinch too risky. will ship, 20$ +shipping

Bolt on 8.8 rear disc brake setup, free99 if you come to my house in San Jose and pick it up. 20$ if you make me ship it, don't want to throw it away. Pulled this off for a 9" swap

My links are 28.5-29" the top link is slightly shorter to set my ride height caster at 6-7 deg, my beams are extended3" with 14" shocks ~18"of wheel travel I get 0.8 deg of caster change ( at bump 0.8 deg more caster than at full droop). As for the sway-bar link it is 4" and I will make it as long a...

Pulled the motor to paint the frame and found a broken piston, I think this happened last year when I broke a rocker arm. Sending 347 to FPS in Anaheim for a short-block rebuild with forged bottom end.

Thanks for the kind words! :!: Next up is front sway bar I could't find a 16" arm with a kick so I'm gonna do my own (screen shot below, note the chargers colors go BOLTS!) I don't have access to a broach so I made the spline section bolt on, this will also allow me to tweak the kick once I mock it ...

Loving the stretch, i think I have stretch envy...

OK its been way to long. Slowly but surely I have completed the engage cage. I also had to order new front body mounts and modify them to clear the radius arms. Just need to finish welding and dial in the limit straps. Also, I'm considering getting the beams nickel or zinc plated has anyone had succ...

Slowly making progress, finally finished up the beams (mostly still need to finish the double shear on the lower shock mounts) and built the upper shock mount. Almost ready to tear it down and install everything just need to find another ride for a bit as this is my daily driver.

Ok its been a while,spent the last few weeks welding 1-2 hours a night, I have got the beams mostly done just need top truss/shock mount and radius arm brackets. passenger side Screen Shot 2018-04-27 at 9.40.51 PM.png Radius arm bracket Screen Shot 2018-04-27 at 9.43.09 PM.png Drivers side Screen Sh...

@ Bobby Velazquez, thanks man

The reamer says "SAE 80 -7/8 car reamer 1/2 shank"

I think the angle is 3.5deg I used this link to get the angle from two diameters and a length

http://www.magafor.com/841/uk.htm

Small update, got my front end back from laser cut, managed to fit everything on a single 3' X 3' sheet of 3/16 4130, I'm also stoked on the lower ball joint mount just need to make a jig to locate it.

I'm jealous my header are rusty!