Sorry had to fight w the issue. Eventually got new cable made. Removed calibration module. Cable has broken twice in the past. I cary a spare cable. She runs good now.
Can't load pics of the bronco,,,, error file too large

Mine is bowed out from the center as if weight caused the bow when in down position. If you look down to the seal from the inside, there is about an inch in the center. Causing the window to not track up or down and the breaker goes off when trying to use the window. Anybody have any ideas on how to...

To purchase... Just shell or with all hardware minus glass. Where to buy on the internet? I've heard its a nightmare to replace a tail gate. Need for 96 bronco. Thanks

96 bronco that is...

The whole TG is bowed out. Bottom of tg is about 3/4 of an inch bowed from center towards sides about 12 inches. Someone must of laid heavy stuff on it. Window trips breaker Cruz of the strain. Window squeezed!?! Has any one used a portapower to attempt to straighten tg some? I can use a cordless ba...

Luv to see more pics of adventure, true tested trailers. I've decided I'm gonna own one soon to tow w my bronco. I want to be able to camp and be self sustained for at least a week. Any custom builders near Washington state?

Howd that work for ya! I need to replace mine too

2, L grey. Come on, christmas!!

ok nevada speedometer can replace the cable i need w the 17teeth gear on end that connects to drive gear in transfer case. the gear on shaft thats in the tcase spins freely. so it will get replaced too. i tested the cable for free spin and its fine. wonder what caused the cable to snap from gear and...

the cable would of been attached to plastic gear right? I cant tell!

so the cable going into tcase has a gear in the end. gear should of had a cable attached to it so it winds up the woodward sensor. that cable was frayed and sheared inside of plastic gear. I guess I'll search for speedo cable w appropriate measurements. thx all. pics??? still gotta work on that.

this woodward is attached to cable going into tcase

thx for all the info. well researched and tested I trust! im still trying to get pics up.

speedo does not register! the wires seem fine under dash. will seek more tomorrow. thx all! where do I get a gofastbroco steeker! I WILL get it to run fast!!

its a 9",,,, info via laptop, just gotta learn how minimize pic size! w no calibration module, my speedo will be way off, right-O?!?! i'll check wires too. fuses r fine. I purchased this rig w a lot of hackin done to it. thx for input all!

well I keep getting msg that pic file is too big.... but the solenoid is a woodward mini gen p/n SA 2650 A, connected to a cable that has two offset connectors/couplings, then has a sensor that fits on end of transfer case. I tighten fitting on one of the double connectors right before sensor to tca...

the vss relocation kit- check! ill get pics up. I appreciate all the input. im gonna get the sucker running yet. on my way to get license n tabs now!

im working on getting a vss setup. it has a connector on tcase that connects to a selonoid n runs to dash. idk what it is. it has a speed calibration module underdash. idk how it works. arb compressor w front n rear lockers. will have to learn how to use. apperantly engine was chipped but I see no e...

looking for expert in bronco offroad world in the area of Wenatchee, omak, tricities, Spokane or grand coulee. ive purchased a 96 4x4 that was buit up. took a chance! 6" bds, lockers, winch, 9", no speedo or overdirve. stock engine n tranny. thx all!