pictures?

A few weeks ago I did the dirver side rotor on my 89. Last night I tackled the passenger side and noticed the 4 pin nut has a side with teeth that match up to another piece. I do not remember seeing that on the driver side. I will tear them both down tonight to compare. any one have any tips/suggest...

nice!!

I've been looking for ideas on a rear bumper but can only find tubular style bumpers. anyone have any to share?

need a kit for an 89 bronco. style A dome light.

6" coils didn't really like them

4" drip brackets, may be an option

Largest cam, would I just order the cam alone?

My issue is that the brackets were made for 6" coil. Now with the 4's its not straight

I am looking to order some ball joints from Rockauto but don't know what to get as far caster/camber. I see so many results come up as far as eccentrics, bushings, cams. What are you all running on your setup. I'm currently running 4" coils with drop brackets and heimed radius arms.

think I've seen these being used on 16 bodies....

I have a set of 3.0*14*400 coils. Will settle for $120 shipped.

I like your choice, 15x7 standard in machined. Wish I could go back and do those instead of the black/silver.

nice project you got there. Looks a lot like my 89.

Replaced the water pump and tie rods over the weekend. Also did a little trimming on the bumper. http://i729.photobucket.com/albums/ww300/ivaneunice/IMAG1086_zps288d9e7d.jpg http://i729.photobucket.com/albums/ww300/ivaneunice/IMAG1087_zpsd48024d5.jpg http://i729.photobucket.com/albums/ww300/ivaneuni...

the small fan benid the grill made a huge difference. I just did close to a two hour wait at the border a few weeks ago, temp was between 190-200 with a/c running the whole time.

I agree Tony, I am running 17" double standard methods in black/silver. If I were to do it again I would go with 15" standard in machined finish.

35" generals red label. Wasn't very convinced on the red label but they were in stock so we'll give them a shot for now.

Been a while since I updated. Never fails, you do one thing and another comes up. I took it in for new tires yesterday, while I was there the water pump went out. So now I have new tires and a bad pump. New stock tie rods came in from rockauto, a whopping $25 shipped for all four. Should be putting ...

Have part numbers on the steering components?

I recently tried an electric fan off a lincoln mark VII in place of the clutch fan. It did ok, but it was still shy on CFM for my application, others have had good results. I will definitely look into it. Is there a wasy to check if the clutch is working well?