Bronco looks awesome you did a great job with it and I am glad it will be used!
-Derek

I used all 4 wheel drive in corona for mine.

It's solo's setup but it looks they just welded a bung and then machined the ring to fit the diff

Truck is located in orange

All the offroad parts have about 75 miles on them. Motor and trans have 140000. New steering box, tie rods.

94 bronco 351 solo 4.5 over beams with solo shocks mounts Fox 2.5 triple bypass, coil overs and 2.0 bump stops. Rear deavers and 3.0 triple bypasses w/ 2.0 bump stops (bump stops not installed). Fully gusseted 9in rear end with disc brakes and Detroit locker. 1.75 cage front to rear 4 prp seats and ...

Sorry I saw sparco seats and I thought I would chime didn't read your post completely again I apologize

I thought the same thing about a hard bottom out but we have had some hard hits and no injuries trying to post some incar of a crash that my partner had while in a tub seat. To me the biggest issue is that when the seat compresses you can come back into the belts in a bad position causing injury. Ma...

I had Sparco's in my 12 car and I absolutely loved them. I have Cobra's in my new 10 car and they seem to be just as good. I have used suspension seats for 10+ years and they caused a lot of pain in my chest and sternum area. Problem completely went away with a tub seat. In a suspension seat you are...

Does anybody make one for the Bronco?

Springs: Top 3.75x8x450, Bottom 3.75x22x450 I am far from a suspension guru, but it doesn't work in my head to call this a dual rate, maybe I'm missing something or naive, but I just dont see the point. Because you have two springs in a series the effective spring rate is determined by 1/k=1/k1 + 1...

Thanks. I am leaning towards putting them in. The seat bar inside the wheel well is in the way so I will need to change how the seat mounts.

I am in the process of finishing my bronco and I have a set of fox 4" bumps and cans that I planned to use in the rear. The truck has F53's and a Fox 3" 3-tube 16" travel shock. It is going to be a pain to mount the bumps and I want to go play with it for awhile. Should I bite the bullet and install...

I will get some better pics next time I see it

Hey all,
I have a 94 5.8 that I am in the process of building. The front has 4" solo beams with a solo shock hoop, fox 2.5 c/o, bypass and bump. Rear is a trussed 9" with f53's and 3" Fox bypass through the bed. Full 1 3/4 DOM cage and four race seats.
Derek